Shrink chuck 4,5° SK 40 - 06 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

radial load

parallelism: 0

- with mode

clamping depth = 41

E3= 6 pieces

For mounting straight-shank tools in collet chucks KPS-system

6 µm radial run-out with a 5 µm clamping nut

For use on static and driven toolholders via threaded connector

Protection level IP65

For adaption from HSK-A to PSC (ISO 7388-1 to ISO 26623-1)

E1= 20 pieces

For cleaning internal tapers on machine spindles