DIY Frame Jig Rotisserie Stand by Chop SourceDIY Frame Jig Rotisserie Stand by Chop Source Get your motorcycle frame jig off the table or lift and make it rotate for easier welding with a Chop Source Frame Jig Rotisserie Stand. The brackets lock in 16 positions and can be moved along their uprights to balance the jig and frame. You need to supply 22'2" of 2"x3" or 2"x2" tubing (1 8" wall) for the the stand (move the feet from your table top jig to the stand). See the assembly instructions for

or your flat track bomber

Harley-Davidson stators and reg/recs in single-phase systems have a habit of damaging multiple components of the charging system when one fails

This affordable seal kit will help you keep your fork juice where it belongs—in your fork

3 Gallon Wassell-Style Low Tunnel Frisco-Style Fuel Tank

Use this kit if you are building a custom frame that needs a 5/8" or 17mm diameter axle

and selection to get you everything you need to build your Sportster right including

Chop Source Standard Frame Jigs come with 3/4" material so you will need to purchase this 1" kit separate from the full kit if you need 1"

Replacement brake pads for Moto Iron Springer Calipers part #116-0050

Many Harley-Davidsons equipped with Evolution engines (Sportster and Big Twin alike) and Twin Cams experience starter failure

These brass petcocks feature one female and one male threaded 1/4" NPT connection for easy installation

the grooves that run to the edge of the tire move most of the water from the path of the tire and the secondary sipes allow the tire to actually accept the water into itself

No special tools needed for installation