Shell mill holder PSK 63 - 40 - 45Application: For mounting milling cutters with transversal groove. Note: d = 40 d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079. Delivery: With drivers, cross head retaining screw and cylinder head retaining screw for cutters with central coolant. For d = 60 only with four fi xation screws according to DIN 912. All holders are made of forged steel Specific, low warpage hardened Surface hardened

With built-in tightening bolt

Axial sealed with two O-rings

clamping depth = 41

2x fixed and 2x steering caster

nuts and plain washers

Designed with fine adjustment to allow precise movement of the slider

Thread configuration with a special design

Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap

for clamping holders with coolant channels directly to the cutting edge

Operating Temperature : -10C~55C

E1= 20 pieces

All functional surfaces fine machined