Shrink chuck 4,5° BT 40 - 12 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Retaining screw for mounting of face mills arbors

sleeves and tool arbors

The steel body is hardened and grinded

Instruction manual

a clip and can be moved in steps of 25 mm

Carbide tipped scriber with clamp

For the storage of collet chuck

is prevented from attaching itself by vacuum

With clamping screw and O-ring

For mounting straight-shank tools

A possible increase of axial force during the tapping process is reduced to a minimum

Graduation: 0