Shrink chuck 4,5° PSK 40 - 16 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of

Hardening depth 0

For machines with rigid tapping

With ball bearing clamping nut All holders are made of forged steel

and are noted for their tailored inner struts

ADJRGA = Length adjustment range

For mounting straight-shank tools in collet chucks KPS-system

Suitable for internal coolant

- Stainless steel 1

With clamping screw

- Especially suitable fore wire EDM

with IC DIN 6499 B (ISO 15488 B)ER-system

tool steel