Rod Holder - Standard & Sealing Cap304 grade stamped polished stainless steel ush mounting. Spot welds holding the shaft to the head. Complete with plug type hinged black PVC sealing cap and rubber mounting gasket and stainless rod gimbal pin through shaft. 3 x 8mm countersunk fastening holes. Head size : 120 x 95mm Length : 210mm Shaft I. D : 38mm Cut out hole size : 50mm Shaft is angled 30 degrees. Supplied per each.

The pumps are delivered including both a straight and a 90° smooth elbow Dura-Port as well as a removable check valve

Pear shaped

Quick one quarter turn release to fold aerial down

skin fittings may be installed in the side of the box

57 15 303816 4

Their precision design provides the optimum number of ball bearings for minimum friction while weight reduction is achieved through the use of fibre-reinforced composites in the block head

115 (1984-05)

Busman 50amp man reset

flexible plastic material which is designed to be wrapped over the top of the transom to protect both sides and top from abrasion by the outboard motor

• 2 x Magnet brackets

They are non-corrosive and IP67 rated to ensure they are reliable and waterproof under the harshest conditions

At the rated voltage