Paints and varnishes. Electrochemical measurement of the protection provided to steel by paint coatings. Current interrupter (CI) technique, relaxation voltammetry (RV) technique and DC transient (DCT) measurements1 Scope This International Standard specifies the procedure for evaluation of the experimental set up of electrochemical measurements on high impedance coated samples using methods that are based on the current interrupter (CI) technique, relaxation voltammetry (RV) or DC transient (DCT) measurements. It provides specific definitions and guidance on optimizing the collection of CI, RV and DCT data from high impedance systems. High impedance in the

BS EN 14456 provides you with the minimum purity requirements for bone charcoal used for the treatment of water intended for human consumption

Certification of RMs for biological safety testing

BS EN 2591-508 shall be used together with EN 2591-100 which is the Aerospace series – Elements of electrical and optical connection – Test methods – Part 100: General

This International Standard specifies the essential performance characteristics of readers with magnification less than or equal to 50:1 designed for use with black-and-white roll microfilm and strips that have a maximum width of 35 mm

Note: ISO/IEC 15693‑3 does not preclude the incorporation of other standard technologies on the card

What is BS EN 4346 – Vacuum induction melted steel for aerospace application about

Using the information security management system (ISMS) family of standards

Why should you use BS EN 2713-005 - Spiral screened and jacketed electrical cable for aerospace applications

and general requirements for

such as Patient Identification Cross-Referencing (PIX)

welding procedures

the increase in crack length per cycle