Glass-reinforced thermosetting plastics (GRP) pipes and fittings. Test methods to prove the design of cemented or wrapped joints1 Scope This document specifies methods of test for cemented or wrapped joints for buried and above ground glass reinforced thermosetting plastics (GRP) piping systems. This document is only applicable to the joint and covers methods of test to prove its design. It assumes that the joint either is or is not intended to be subject to the effects of hydrostatic end thrust. The tests detailed in 9. 2, 9. 4 to 9. 6 inclusive are applicable to cemented or

so that companies tendering for FM services and those providing the services will all have the same understanding

to optimize the use of personnel

7 Protection of power circuits within a wind turbine

• Publications referred to

develop and implement a supply chain security plan

ready-to-feed liquids and liquid concentrates) by reversed phase high performance liquid chromatography

The tests described in all the standard are type tests (laboratory tests) and not quality control tests carried out during manufacture

This document provides a method for sampling compressed air and a guide for choosing suitable measuring equipment to determine its particle size and concentration by number (to be referenced as “concentration” throughout this document)

— evaluation of the type-approval test results

the whole system in which the packaging takes part should be optimized

proton density)

government or non-governmental organizations