Milling Chuck PSK 63 - 20 - 75Application: For mounting straight shank tools. All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

- Double-clamping via two mobile and one fixed jaw

- with mode

Parallels are widely used as a tool for tensioning and positioning

Application:

driving ring and feather key

For mounting and drifting taper shanks DIN 228-1 A in toolholders DIN 228-1 B

Functional parts hardened and ground

Suitable for mass production

Metric/Inch conversion at any position

Protection level IP65

edge radius 1 mm

Stahlkörper allseitig geschliffen und gehärtet