BH1750 Digital Light Intensity Sensor ModulePin Configuration of BH1750 Sensor Pin Number Pin Name Description 1 VCC Power supply for the module can be 2. 4V to 3. 6V, typically 3. 0V is used 2 GND Ground of the module, connected to ground of the circuit 3 SCL Serial Clock Line, used to provide clock pulse for I2C communication 4 SDA Serial Data Address, used to transfer the data through I2C communication 5 ADDR Device address pin, used to select the address when more than two modules are

Pin Configuration of BH1750 Sensor

A pressure sensor works by converting pressure into an analog electrical signal

Each I2C chip connected to the same SDA/SCL wires needs a unique address

pk this quadcopter frame used to build a flying drone

Analog Input: C0-C15 16 channels

Increased DC Power supply Interface

or 5S batteries

Overall length: 2

The board size: 16 mm * 44 mm

display and SD card slot

It can be powered by the USB cable or by an external 9-volt battery

Temperature Coefficient Resistance: ±400 ppm/°C