Shrink chuck 4,5° with cooling channels HSK 100 - 08 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Bed height H: 0

Flatness: 0

Angle reading = 10 arcmin

206 x 56 x 24

bei Ø 6 – Ø 32 mm = h236

With clamping screw and O-ring

The tapered tool holder is thus optimally

- Calibration of the angular position of spindles of milling-turning centres

Metal housing with rotating lever gauge

For mounting the coolant tubes in HSK toolholders

For mounting milling cutters with transversal groove

Not applicable with reductions