JXB Driveshaft Center Support Bearing Carrier Upgrade - VW/Porsche / 7P Touareg / 958 CayenneHolds the driveshaft where it should be. Isolation dampers minimize vibrations. The ProblemThe stock center support bearing carrier holds the driveshaft in place with rubber so thin about 20 lbs. of force moves it from center to the end of its travel. While thats great for making sure no NVH makes it to the cabin, the stock bushing is extremely prone to failure, especially in harsher climates and on higher powered cars. Even on the best kept cars, the

weighs only 9lbs

Do not be fooled by others claiming “Full” or “Ultimate” catch can system

OE Part #   2046801400K

Made of T309 (1

make it a reality with custom parts from IND

Our baseline run was performed on a 335i running 16psi of boost with the stock F-Series intercooler

000 Mile Warranty

sent them the full set of drawings as well as the extra manifold we have so they could begin doing a 100% faithful recreation of what FF had developed a few years back

Long rack with tie rods and boots

Coolant Flange O-Ring (50x3

align with the factory jack pad under the car and lift the car correctly

We have removed the highly restrictive OEM catalytic converter and replaced with a high performance 200 cell Sport Cat (Shown in 2nd photo) that flows much high volumes of air and increases horsepower and torque