M.A.D. Microphone Attachment DeviceThis product was designed by me after searching for a way to hold a shoulder microphone to my uniform and not finding anything satisfactory. It is injection molded out of ST801 Nylon and is surprisingly strong. The clip is designed to go into a uniform pen pocket. Once you run your shoulder mic across your back and over your shoulder, simply clip it to the holder. It keeps your all important communication device centered on your body so you can easily

The blade has a 6 inch cutting edge and the knife is 11 1/2 inches long over all

Once you run your shoulder mic across your back and over your shoulder

but it must be on the camera for it to fit properly in the MOLLE sleeve)

1/2" thick brass double rings with an antiqued finish

you need to have the magnetic attachment with the buttons shown in the photos (the mount doesn't use the buttons

1/2" thick brass keychain and defensive tool

so these photos aren't great since they were taken on my desk

They are 3/16 inch thick 80CRV2 with a 4 1/2 blade (4 inch cutting edge on the longer edge) and 1/4 inch thick handles

maybe a little pleasure

Mainly the shaft for the spike is a little longer and the finger rests are slightly shorter to help with comfort

I'm calling this the Mars XL because

I usually try to take photos outside to get the colors correct