DSL010 - Driveshaft Safety LoopApplication: 2005 2010 Ford Mustang Protect your 2005 2010 Mustang, while complying with NHRA safety rules with a Driveshaft Safety Loop from BMR Suspension. If you drag race your S197 Mustang, chances are you need a driveshaft safety loop to be NHRA legal. Built from 1 4 inch laser cut CNC formed plate steel, BMR's DSL010 Driveshaft Safety Loop bolts on using OE mounting holes from the factory transmission crossmember. This design gives you a solidly

Revised lower plenum & runner geometry for increased power and throttle response

transfer case yoke and hardware (pinion flange bolts will be reused)

This driveshaft also includes a bushing which should be trial fit to the output shaft of the transmission

This can be used on Gen1/2 engines when using a Gen 3 rear main seal

This ensures the customer will not have to worry about a bond failure after install

The AlloyWerx billet intake manifold is the ultimate upgrade for serious HEMI  builds

transfer case flange and hardware (pinion flange bolts will need to be reused)

The shirts are pre-laundered to prevent shrinkage

The precision-milled face enhances ball contact

but from time to time other vendors may be used

Application: 2015 – up Automatic Hellcat/Demon ONLY

This kit comes with three block offs and one cam sensor